Guangzhou Shice Equipment Co., Ltd.
Quality is our life.
Add to Cart
IEC60061-3 E5 Go And Not Go Gauge Screw Thread Lamp Cap Gauge
Gauge Name:
| IEC60061-3,7006-25D-1 | "Go"gauges for E5 caps on finished lamps |
| IEC60061-3,7006-25E-1 | "Not Go"gauges for E5 caps on finished lamps |
7006-25D-1 Go gauge for caps on finished lamps
PURPOSE:
To check the thread and dimension T min. of B5 caps on finished lamps.
TRSTING:
When the cap on a finished lamp fully acrewed into the gauge, the contact-making
shall be co-planar with or project beyond wurface S.
This gauge may also be used for checking unmounted caps.
7006-25E-1 Not go gauge for caps on finished lamps
Purpose:
To check the minimum outside (major) diameter of the screw thread, dimension d, of E5 caps on finished lamps.
Testing:
When the gauge is placed over the thread of the cap on a finished lamp, held cap uppermost, the centre contract shall not project beyond surface X. Only the weight of the gauge itself shall be used in the test.
Part of customers and certification:
